Low memory and timeout error when updating firmware

Firmware Veröffentlichungen und Einstellungen können hier angekündigt und diskutiert werden.
Antworten
john.iestyn
Frischling
Frischling
Beiträge: 3
Registriert: So 8. Sep 2019, 13:58
Wohnort: 10 Richmond Court, Adhton Keynes, Swindon, WIlstire, SN66PP

Low memory and timeout error when updating firmware

Beitrag von john.iestyn »

Hello,
I have an rf1000 and i am trying to update to the latest community stable release of the firmware and i get a low memory warning when i try to compile the file and if i do try to upload the firmare i get a a timeout error.
Any help would be very much appreciated, sorry for the terrible german translation below but i seem to be one of the few english speakers with this printer so its always a fun challenge translating the forum posts with my awful german and google translate

Hallo,
Ich habe eine RF1000 und versuche, auf die neueste Community-stabile Version der Firmware zu aktualisieren. Beim Versuch, die Datei zu kompilieren und beim Hochladen der Firmare wird eine Warnung angezeigt, wird ein Timeout-Fehler angezeigt.
Jede Hilfe wäre sehr dankbar, entschuldige die schreckliche deutsche Übersetzung unten, aber ich scheine einer der wenigen englischen Sprecher mit diesem Drucker zu sein, so dass es immer eine lustige Herausforderung ist, die Forenbeiträge mit meiner schrecklichen deutschen und Google-Übersetzung zu übersetzen
Benutzeravatar
AtlonXP
3D-Drucker Erfinder
3D-Drucker Erfinder
Beiträge: 3373
Registriert: So 15. Nov 2015, 20:55
Has thanked: 742 times
Been thanked: 588 times

Re: Low memory and timeout error when updating firmware

Beitrag von AtlonXP »

Hello john.iestyn,
the translation is first class from Google.
The low memory error is normal and can be ignored.

To time out:
Arduino cannot connect to your printer.
No other program except Arduino IDE may be active,
where to access the printer.
The baud rate should be 115 200 and the correct COM must be selected.
Are your other settings in the Arduion IDE correctly set for the RF1000?
In the manual from Conrad, there are instructions on how to set up the Arduino.

For our community FW you need the Arduino Ver. > = 1.8.5

This is also a translation by Google.

LG AtlonXP
Antworten

Zurück zu „Firmware / Tweaks“