Hi I bought broken rf2000v printer. Filament was stuck inside hotend. I have managed to clean all of it but there is one question. Almost all of hotend its fi 3mm diameter inside for filament guide. Parts made from peek seems to have 4mm diameter of guide. Is it right for 1.75mm ? Original E3d has s...

I am still testing it but I don't see any difference between original 1.75 and this one in printing quality.
Maybe it should be little better since extruder use gear and for sure it is more precise.

You can buy clone form aliexpres with two versions. One has no bearing on motor shaft so shaft is rotating over extruder arm and wear it out. Second has bearing and this one works for me well. I made fan duct, i used blower it has quite big power. https://www.thingiverse.com/thing:3813963 IMG_201908...

Hi! I would like to show you my conversion of RF1000 printer. Some time ago I had RF2000 and bigest issue was hotend. I broke 2x of original hotend, one of them after 1h of print time so I knew that it is poor quality. Few days ago I bought RF1000 printer and put new mosquito hotend and titan clone ...

I do not think it is a nozzle problem. Maybe terminstor was wrong so printer overheated it or maybe peek material is poor quality and it did not took 220 degrees as it should. Also it can be problem with thread between peek material and nozzle brass end but I didn't want to dissasamble it due to war...

Hi
Today I installed new hotend to my RF2000
After 2min of work it is gone.
Is it normal ?
I bought two and I dont know if I should install second one.
Moreover old 3mm hotend died same. One I use has already 100h and still working.

You pay 2k euro and still this is reprap ...

What carbon plate did you used? 4-5-6mm? What about heating it up. If i will not buy original glass bed i consider using anycubic ultrabase plate that I will cut by water jet router About a glue. Several times i used loctite EA9492 this is resin glue up to 180celsius I used it to glue ceramic resist...

Hi!

Sorry I write English but my teacher of German was horrible :]

I would like to buy glass plate for RF2000
Mine is broken in a half so I need to change it.
I do not need heating element I would use one I already have.

You can send me info on prv or email filipgd@gmail.com

Best regards